HSS Hand and Machine Taps
1/4 x 26 BSF INTER MACHINE NUT TAP
Tools & Gear Taps & Dies HSS Hand and Machine Taps
HSS Machine Nut Taps Machine Nut Taps are used where a long shank is needed and are available in Taper - Intermediate - and Bottoming leads. To ensure easy and precise use the Machine Nut Tap Taper lead has a unique - very long entering chamfer. This makes aligning the cutting end with the work piece simple. Ideal for tapping nuts - small quantities made from tough steel such as stainless steel as well as mild steels - or for rethreading rusty or worn threads. Alternatively - the Intermediate and Bottoming leads are ideally suited to long reach threading applications where the thread needing to be tapped or cleaned is beyond the reach of a standard tap. We recommend the Intermediate lead Machine Nut Tap for long reach through-hole applications and the Bottoming lead for long reach blind hole applications. BSFBRITISH STANDARD FINE <BR>This thread form was based upon the British Standard Whitworth (BSW) but has a finer thread (more threads per inch for a given diameter). The thread form was first introduced in 1908 and is specified in BS84:1956. When used on external threads this series has greater tensile stress area than coarse threads of the same size. Fine series threads will resist stripping out better than coarse threads in areas where the external and mating internal threads are subjected to loads equal to or greater than the capacity of the screw or bolt. Fine threads are also used where the length of engagement is limited or where wall thickness demands a fine pitch. INTERMEDIATE TAPS have a lead of four threads and are used in most general purpose applications to cut a thread true to a pre-drilled pilot hole. Manufactured from HSS.
Recommended Products
HSS Hand and Machine Taps
TAP HSS 3/4 x 10 UNC INTER
HSS Hand and Machine Taps
TAP HSS M24 x 3 + 0.45mm SET
HSS Hand and Machine Taps
TAP HSS MF 18.0 X 1.5 INTER